Warning: Last items in stock!
Original KME Fenix 1 cyl injector. Designed for sequential gas volatile phase gas installations.
The injector is responsible for the precise dosing of the vaporized LPG gas to each cylinder of the engine.
The capacity is regulated by nozzles.
The advantage of the KME Fenix injector is its speed and short stable opening times. Thanks to the dosing solution and high gas flow rate, it can work with directly fuel injection. The injector is resistant to damage and low temperatures thanks to seals made of rubber-based mixtures and a fluoropolymer sliding coating (non-stick and anti-freeze).
When mounting FENIX injectors, you can use either manifolds, or dedicated elbows, and knees. It is a very helpful tool for an installer, as they facillitate mounting the injector, even in dicult to access area.
Coil resistance: 1.9 Ω (± 5%)
Opening delay: 1.7 m / s
Closing delay: 1.2 m / s
Min.stable opening time: 1.55m / s
Max. working pressure: 4.5 bar
Max. flow at pressure 1.0 BAR: 120 nl / min
Working temperature: -20ºC - + 120ºC
Approval: E8 67R-018502 / 110R-018503
Connector: Superseal 2-pin
Max. nozzle diameter: 3.0 mm
Max. power: 60 ÷ 65 HP | KM
Max. holding current: 2 A
Max. opening current: 6 A
Lifetime: > 500 million cycles
Flow regulation: ussing calibration nozzles
Power supply voltage: 12 ÷ 16 V.
KME Fenix single injector - 1 piece
Injector calibration nozzle - 1 piece
Suction manifold stub - 1 piece
No customer reviews for the moment.